Development Trend of Vacuum Coating

Nowadays, there are two main ways to make the coating industry, one is chemical meteorological deposition, that is chemical coating (CVD), and the other is physical meteorological deposition, that is vacuum coating (PVD). Chemical coating is a process of introducing a gaseous reaction agent or other gases needed for the liquid reaction into the reaction chamber, and a chemical reaction occurs on the substrate surface to form a thin film. In the process of chemical film, it is easy to produce solution pollution, if the coating surface impurities, the effect of plating is not good.

2022-03-13

Basic technical requirements for vacuum coating equipment

1. The structural form of vacuum pipes, static sealing parts (flange, sealing ring, etc.) in the equipment shall comply with the provisions of GB/T6070. 2. Vacuum measuring pipe shall be installed on the low vacuum and high vacuum pipes and on the vacuum coating chamber to measure the vacuum degree of each part respectively.When the electric field is found to interfere with the measurement, the electric field shielding device shall be installed at the measuring port. 3. If the main pump used by the equipment is a diffusion pump, a trap trap shall be installed on the side of the air inlet of the pump. 4. The coating room of the equipment shall be provided with an observation window and a baffle device.The observation window shall be able to observe the operation of the deposition sources and other key parts. 5. The design of the ion plating deposition source should improve the dissociation rate in the coating process as far as possible, improve the utilization rate of the coating material, reasonably match the power of the deposition source, and reasonably arrange the position of the deposition source in the vacuum chamber. 6. Reasonable arrangement of the heating device, the general heater structure layout should make the coated workpiece temperature rise uniform. 7. The workpiece frame shall be insulated from the vacuum chamber body and the workpiece frame shall be designed to uniform the workpiece film layer 8. Ion coating equipment should generally have workpiece negative bias and ion bombardment power supply, ion bombardment power supply should have inhibitory abnormal discharge device to maintain working stability 9. The insulation resistance of the vacuum chamber is 4.4.6 in GB/T11164-1999 10. Other attention matters:

2022-03-13

Warm congratulations on the completion of the C.G. Vacuum website

Since its establishment in 2001, Chaozhou Chuanggao Vacuum Equipment Technology Factory (C.G.Vac) has been deeply engaged in the field of high vacuum technology, facing the global market, and is committed to providing customers with vacuum application solutions, developing, producing and selling all kinds of high vacuum coating equipment and high vacuum acquisition units. Over the years of industry accumulation, the establishment of a senior technical expert team, accumulated rich development experience.

2022-03-11